How to reset the 2013 dodge caravan check engine light?

In this blog post, we will answer the question “How to reset the 2013 dodge caravan check engine light?” We will talk about checking the engine light and why does the check engine light indicate. We will also describe resetting the dodge caravan check engine light and talk about how far you can drive after resetting the check engine light.

How to reset the 2013 dodge caravan check engine light?

To reset the 2013 dodge caravan engine light, there are a few simple steps that need to be followed. The first and simplest step is to follow is to switch off the ignition and switch it on again. Do this a couple of times and there is a chase for the check engine light to disappear automatically. 

The most important part is to identify the cause of this issue. The check engine light can flash due to a damaged oxygen sensor. The head gasket can be faulty or the sensor can even be dirty. Some vehicles can also experience a malfunction with the fuel injection system. 

Only an expert can identify the problem so it’s best to get your vehicle restored to the factory specifications. The dodge caravan is designed with high technology and it has an excellent performance monitoring system. There are several sensors placed in the right positions to monitor any issues. 

These sensors send data to the electronic control unit. Just be prepared and pull over to the next mechanic if this problem occurs. However, there are a few ways to reset this engine light on your own. Here are a few steps mentioned below. These steps can help you out when you are stuck in a tough situation. 

Resetting the check engine light

The dodge caravan usually rests the check engine light on its own after the problem is discovered and solved. There are a few other ways to reset the check engine light on your own. In some cases, the check engine light can also be a false alarm, but these situations are very rare. Here is how you can reset the check engine light on your own.

Disconnect the battery

The first step would be to disconnect the battery. When you find that the vehicle is running fine and there are no major issues, you can go ahead by disconnecting the battery. You can do a manual reset by just following a few steps. If you are familiar with your car, you can do this on your own. Yet, it is always better to hire a professional.

  • Start by turning off the ignition.
  • Find the negative terminal of the battery.
  • Loosen the nut on the negative terminal by using a wrench.
  • Disconnect the negative connector from the battery and wait for a minute or two.
  • Reconnect the negative cable and tighten it once again with the wrench.

Finding out the issue

  • The next step would be to troubleshoot the issue. This is recommended if the check engine light continues to flash or burn despite disconnecting or reconnecting the negative cable.
  • Removing the gas cap and tightening it once again will help. Loose gas caps have always been an issue and you can figure this out on your own.
  • You can also try repeating the steps mentioned above. 
  • If you are lucky enough it can be a simple issue. 
  • Most of the time, you should be able to detect what is wrong with your vehicle. 
  • The 2013 dodge caravan check engine light is an important feature for your vehicle. Make sure you take it seriously when the light indicates.

Why does the check engine light indicate?

There is nothing to be done from your side since the 2013 dodge caravan engine light will reset itself. One example is the loose gas cap. If the light indicates due to a loose cap it will automatically disappear after the cap is tightened. This is common in most vehicles and there is nothing for you to be afraid of.

The 2013 dodge caravan engine light is designed to go off after a point in time. In most situations, the light can go off after 20 to 40 miles. The engine light indicator is important in every vehicle and just like the other vehicles, the dodge caravan has a list of reasons for the engine light to turn on. Here are the reasons listed below.

  • Loose gas cap.
  • Missing gas cap.
  • Bad spark plugs.
  • Ignition system faults.
  • O2 sensor faults.
  • Transmission issues.
  • Fuel and air metering system issues.
  • Old battery.
  • Emission control issues.
  • Computer output circuit issues.

Those are the most common issues for a dodge caravan engine light to turn on. With the above-mentioned issues, you will still be able to drive your dodge caravan for a while. However, it is best to take it sooner to a mechanic. Never panic and pull over or tow your vehicle unless it is necessary. Remember that the engine light is a part of the vehicle’s diagnostics system.

Check for warning signs

The engine light gives you enough time to take your vehicle to a mechanic. It might just be an indication to service your engine soon. The indication always appears in advance but some situations can be severe. Often it might be time to change the sparkplug. Irrespective of the reason, get your dodge caravan check as soon as possible.

  • The dodge caravan will give you an indication if there is something wrong with your vehicle.
  • When the engine light starts to blink, it is time to give your dodge caravan for service. 
  • While it might be common, it is advised that you check the vehicle as soon as you get this indication. In some cases, it might just be a loose gas cap.
  • The engine light is a warning for your vehicle that there is something wrong. Some situations can be critical while some can be normal. 
  • The best thing to do is take your vehicle to a mechanic. Ignoring the engine light is not recommended since it can also be a serious issue. 
  • You don’t need to pull over immediately and tow your dodge caravan.

2013 dodge caravan key features 

  • The 2013 Dodge caravan has been a successful model and Chrysler has continued to bring out new and improved versions of the dodge caravan. These cars have an excellent reputation due to their durability and endurance. 
  • The Dodge caravan has developed over the years and they also have an incredible towing capacity. The latest Dodge caravan has a towing capacity of 3,600 pounds.
  • The Dodge caravan has some impressive features and specifications. The newer models have the latest technology and are one of the best towing vehicles. 
  • The dodge caravan gives you an excellent camping experience and this vehicle can also be used for a large family. 

Driving with the check engine light

There is no particular number as to how many miles you can drive after the check engine light blinks. If the problem is serious, then you might not be able to drive as long as you please. Driving more than 30 to 100 miles is not advisable and be sure to take to it a mechanic even if the light does not appear.

  • Maintaining your dodge caravan is the best way to avoid such situations. 
  • Take your car to the mechanic every six months for a general check and this will help to determine any upcoming issues in the future. 
  • You can also be prepared much in advance when such situations arise. 
  • The check engine light might take some time to disappear even after the problem is solved.
  • Remember that the internal computer needs time to reset and this can take a while. 
  • The internal computer will need time to examine all sensors and this reset can happen after driving for close to 100 miles or around 10 to 20 cycles later. 
  • Do not panic if the check engine light is still present even after fixing the issue.

The 2013 dodge caravan has some of the best features in terms of safety and precaution. This car was built to tow and carry a large family. The camping experience can also be incredible and it has enough space and the overall build of the vehicle is strong. The latest model has better features and towing capacity than its predecessors.


In this blog post, we have answered the question “How to reset the 2013 dodge caravan check engine light?” We have talked about checking the engine light and why does the check engine light indicate. We have also described resetting the dodge caravan check engine light. 


Was this helpful?

Thanks for your feedback!